- Bộ lập trình PLC, cáp lập trình
- Màn hình HMI
- Cảm biến, phụ kiện
- Biến tần, khởi động mềm
- Máy cắt, Aptomat, khởi động từ
- Thiết bị đo lường, bảo vệ
- Thiết bị công nghiệp, tự động hóa
- Thủy lực, khí nén, van công nghiệp
- Motor, Servo motor, Servo Amplifier
- Thyristor, Module, SCR, SSR, Diode
- Phụ kiện tủ điện và vỏ tủ điện
- Cáp điện, ống bảo vệ cáp
- Thiết bị điện trung thế, truyền tải
- Thiết bị chống sét, kim thu sét
- Dụng cụ cầm tay, dụng cụ tool
- ATS, UPS, tụ bù, cuộn kháng
-
Thiết bị ngành xi măng, thép, nhiệt điện
-
Thiết bị thanh lí-hàng tháo máy
chuyển đổi tín nhiệt độ 5334A3B
PR5334A temperature transmitter
Product Features
◆ TC input
◆ High measurement accuracy
◆ galvanic isolation
◆ Programmable sensor error value
◆ Adopt top mounting method according to German industrial standards
Product introduction
Application: Linear temperature measurement using a TC sensor. The two-stage mV signal is extended to a 4-20 mA signal, which is linear according to the linear function.
Technical Features: Within a few seconds, the user can set the PR5334A so that it can measure all temperatures in the TCrange. Use the built-in temperature sensor for cold junction temperature compensation. Continuously detect important stored data for security.
Installation: Top-mounted installation according to German industry standards.
Product Features
◆ TC input
◆ High measurement accuracy
◆ galvanic isolation
◆ Programmable sensor error value
◆ Adopt top mounting method according to German industrial standards
Product introduction
Application: Linear temperature measurement using a TC sensor. The two-stage mV signal is extended to a 4-20 mA signal, which is linear according to the linear function.
Technical Features: Within a few seconds, the user can set the PR5334A so that it can measure all temperatures in the TCrange. Use the built-in temperature sensor for cold junction temperature compensation. Continuously detect important stored data for security.
Installation: Top-mounted installation according to German industry standards.
Tình trạng sản phẩm:
Technical Parameters
| Ambient temperature | -40 °C ~+85 °C |
| Power supply voltage, DC | 7.2 ~ 35VDC |
| Maximum offset | 50% of the selected maximum |
| Internal consumption | 25mW ~ 0.8W |
| Cold junction temperature compensation | < ±1.0 °C |
| Signal range | 4 ~ 20mA |
| Minimum signal range | 16mA |
| Reaction time | 1 to 60s |
| Update time | 440ms |
| Load Resistance | ≦(Vsupply-7.2)/0.023Ω |
| Minimum span | 5mV |
| Input resistance | 10M Ω |
Technical Parameters
General specifications:
Ambient temperature
-20 ° C ~ +60 ° C
Supply voltage universal
21.6 to 253 VAC, 50 to 60 Hz or 19.2 to 300 VDC
Reaction time
0.4 to 60s
Protection level
IP65
enter
Current input:
Measuring range
-1~25mV
Programmable, measuring range
0 to 20, 4 to 20 mA
Input resistance
Nom.20Ω+PTC25Ω
Voltage input:
Measuring range
-20 mV to 12VDC
Programming, measurement range
0 to 1/0, 2 to 1/0 to 10/2 to 10 VDC
Input resistance
Nom.10MΩ
Output:
display:
Display readout
-1999～9999 (four digits)
Decimal point
Programmable
Digital height
13.8mm
Show upgrade
2.2 times / sec
Inputs outside the input range are displayed in descriptive text
Current output:
Signal range
0~20mA
Programmable signal range
0～20/4～20/2～0/20～4mA
Load (maximum)
20mA / 800Ω / 16VDC
Load stability
<±0.01%of span/100Ω
Relay output:
Relay function
location point
Hysteresis
0.1 to 25% / 1 to 2999
Switch delay
0 to 3600s
Sensor error detection
Make/Break/Hold
Maximum voltage
250VRMS
Maximum current
2A/AC
Maximum AC power
500VA
24VDC maximum current
1A
temperature range
-20°C to +60°C
General parameters
voltage
7.2...35 V
Internal power consumption
25 mW...0.8 W
Voltage drop 7.2 VDC
Isolation voltage, test
1.5KVAC/250VAC
Preheat time
5 minutes
Communication interface
Response time
1...60s
EEprom error check
< 3.5 s
Signal input dynamic 18bit
Signal output dynamics
16bit
General standard
Input type
Absolute precision
Temperature Coefficient
All ≤±0.05% span < ±0.01% span / °C
Basic standard
Input type
Basic accuracy
Volt ≤ ±10 μV ≤ ±1 μV / °C
TC type: E, J, K, L, N, T, U ≤ ± 1 ° C ≤ ± 0.05 ° C / ° C
TC type: R, S, W3, W5, LR ≤ ± 2 ° C ≤ ± 0.2 ° C / ° C
Signal/noise ratio
>60 decibels
Electromagnetic compatibility anti-jamming effect
<±0.5% span
NAMUR NE 21, standard, burst
<±1% span
Calibration temperature 20...28°C
vibration
IEC 60068-2-6 Test FC
Lloyd's Code no.1
4 g / 2...100 Hz
Maximum diameter
1x1.5 mm2 steel strand
Relative humidity < 95% RH (non-cond.)
Dimensions Φ 44 x 20.2 mm
Protection level IP68/IP00
weight
50g
Electrical specifications, enter the maximum offset 50% of the maximum
Thermocouple input
Type Minimum Temperature Maximum Temperature Minimum Span Benchmark
B
400°C 1820°C 100°C IEC584
E -100°C 1000°C 50°C IEC584
J -100°C 1200°C 50°C IEC584
K -180°C 1372°C 50°C IEC584
L -100°C 900°C 50°C DIN 43710
N -180°C 1300°C 50°C IEC584
R -50°C 1760°C 100°C IEC584
S -50°C 1760°C 100°C IEC584
T -200°C 400°C 50°C IEC584
U -200°C 600°C 50°C DIN 43710
W3 0°C 2300°C 100°C ASTM E988-90
W5 0 ℃ 2300 ℃ 100 ℃ ASTM E988-90
LR -200°C 800°C 50°C GOST 3044-84
Cold junction temperature compensation
< ±1.0°C
THÔNG TIN THANH TOÁN
| |||||||||
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
TÂN THÀNH CAM KẾT
- Sản phẩm, hàng hóa chính hãng.
- Giá cả cạnh tranh.
- Dịch vụ chăm sóc khách hàng tận tâm.
Thông Tin Công Ty
Chính sách và quy định
Đã thông báo
Hỗ trợ khách hàng
THÔNG TIN LIÊN HỆ:
-------------------------------
CÔNG TY TNHH THIẾT BỊ CÔNG NGHIỆP TTH
Trụ sở: số 124 ngõ 79 Yên Hoà-Cầu giấy-HN
Kinh doanh 1 : 0816.861.515
Kinh doanh 2 : 0836.861.515
Kinh doanh 3 : 0926.511.515
Kinh doanh 4 : 0916.861.515
Kinh doanh 5 : 0888.868.515
Kinh doanh 6 : 0917.971.515
Website: http://tanthanh-automation.com
Website: http://thietbitudongtanthanh.com
Website: http://diencongnghieptanthanh.com
Email: tthkinhdoanh@gmail.com
Email: tthkinhdoanh01@gmail.com
